Shotgun Stock Riser Set — 18 Pieces, 9 Sizes (PETG, Laser-Etched)

• 🧱DIAL IN YOUR COMB. THEN DO IT AGAIN NEXT WEEKEND.🧱

• 18-PIECE SET — NINE SIZES, TWO OF EACH. Your stock has two posts, so every riser ships with its twin. No digging through a bag looking for the mate while your squad is waiting.
• Sizes included: 1/32", 1/16", 1/8", 5/32", 3/16", 1/4", 5/16", 3/8", and 1/2" — a matched pair of each.
• 1/2" (0.500") inner diameter — slips over standard adjustable-comb stock posts. Measure your posts before ordering.
• Printed in PETG — not PLA. Impact resistant and far more heat tolerant, so a summer afternoon in a closed truck won't soften or warp them, and a cold morning won't make them brittle.
• Sizes are laser-etched into the material, not printed labels or ink. They don't rub off in a range bag.
• They stack. Nine sizes combine into a long list of comb heights. Find your number once, write it down, and rebuild it in about fifteen seconds.
• Built for the clay games — trap, skeet, and sporting clays, plus any gun that gets shared between shooters or switched between stations.
• Polymer against your hardware: no metal-on-metal, no marring, and quiet.
• We guarantee that IF IT BREAKS, WE WILL REPLACE IT AT NO CHARGE. (Trust us..... it won't break.)
• Printed and etched in-house by FicaraCo. Ships as a set of 18 in a resealable bag.

How they're used

1. Back the comb hardware off and lift the comb clear of the stock.
2. Slide the same size riser onto each post — always a matched pair, or the comb sits crooked.
3. Reseat the comb and snug the hardware down.
4. Pattern the gun, adjust up or down a size, and note the combination that put your pattern where you look.

Risers only — firearm, stock, and comb hardware are not included. Confirm your post diameter and that your stock accepts spacers before ordering.